crwdns2933803:06crwdne2933803:0
crwdns2933797:0thetechguycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 thetechguy
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Front Half - ZR & R buttons |
|---|---|
| + | [* orange] The ZR button can be removed once the red circled screws are removed. |
| + | [* yellow] The R button is underneath the ZR button and is easily removed once the ZR button is out of the way. There is a small hole that one end of the R button fits into. |
| + | [* red] Remove three PH0 screws, two that hold the ZR button plastics and one on the top main board. |
| + | [* violet] The processor for the controller can be seen on the top main board. See the details in Step 9?? |
| + | [* light_blue] The connector between the top and bottom boards is shown here. |
| + | [* blue] The bottom board on the right controller is small and only picks up the bottom three buttons which using a small 6 pin connector. |
| + | [* green] Warning: Do not try to remove the top main board before you remove this small button board in the next step. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0