crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0Robert Wilcoxcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Test before closing
-[* black] If everything works, put back PCB with dock-connector first in.
-[* black] Connect all flex connectors
-[* black] Put all screws in place
-[* black] DO NOT CLOSE COVER
-[* black] Test function again with cover OPEN. Test 3G ON/OFF several times. Especially when screws are tightened !
-[* yellow] WHY ? Because I had to UNTIGHTEN some screws, otherwise 3G SIM would repeatedly fail. I have not found out why. So I have placed a spacer between PCB and case around SIM-Slot. This should hopefully not happen to anyone else ;-) Should you need the spacer, be aware that the spring contact between PCB and 3G antenna needs to be widened a bit
+[* black] If everything works, put the PCB board back with the dock-connector in first.
+[* black] Connect all 8 of the flex connectors.
+[* black] Screw all 11 screws back into place.
+[* black] DO NOT CLOSE THE COVER.
+[* black] Test the function of the device again with the cover open. Test 3G to see if it comes on several times to see if it is still working. Test especially after you tighten all of the screws.
+[* yellow] Loosen some of the screws if the 3G SIM is failing because this could be the cause of that problem. If you need to, insert spacers between the PCB board and case around the SIM-Slot. Be aware that the spring contact between the PCB board and the 3G antenna needs to be widened a little.