crwdns2933803:07crwdne2933803:0
crwdns2933797:0Jim Tomascrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jim Tomas
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] This is where you need to be the most careful. |
|---|---|
| + | [* black] Unscrew the three screws securing the image sensor |
| + | [* black] Carefully remove the image sensor |
| + | [* black] A rubber gasket and protective lens separate between the sensor assembly and sensor itself. |
| + | [* black] Turn the assembly over to remove the glass and gasket. |
| + | [* black] Spray the gasket, glass, and sensor with canned air. |
| + | [* black] Reassemble the sensor, placing the glass in the assembly. It should fit snugly. On top of the, place the gasket, square side towards the glass, with the oval piece facing where the sensor was. |
| + | [* black] When reattaching the sensor, it may help to have the screws already in the hole then hovering slowly back in to place. Be very careful not to let the sensor touch anything. Screw down the sensor, then follow these steps in reverse order to reassemble. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0