crwdns2933803:05crwdne2933803:0
crwdns2933797:0knipwimcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 knipwim
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] charging | |
| [* black] Connect the ventilator back to the AC power. | |
| - | [* red] Make sure the battery is properly installed by verifying that the yellow Battery (charged) LED on the front panel flashes. The flashing LED indicates the battery is being charged. |
| + | [* red] Make sure the battery is properly installed by verifying that the yellow ***Battery (charged) LED*** on the front panel flashes. The flashing LED indicates the battery is being charged. |
| [* icon_note] A new battery must be charged for at least 5 hours before being placed into service. | |
| - | [* icon_caution] Following battery installation, if a ***Check Vent*** or ***Vent Inoperative*** alarm occurs during the preoperational check, discontinue use of the ventilator immediately and contact Respironics. The ***Vent Inoperative*** alarm occurs if AC power is disconnected and a battery is not installed, or if the battery is fully discharged. |
| + | [* icon_note] The manufacturer recommends that the ventilator’s batteries be fully charged before ventilating a patient. If the batteries are not fully charged and AC power fails, always pay close attention to the level of battery charge. |
| + | [* icon_note] The ventilator charges the battery whenever the ventilator is connected to AC, with or without the ventilator switched on. The ***Battery (charged) LED*** flashes to show that the battery is being charged. |