crwdns2933803:06crwdne2933803:0
crwdns2933797:0Lukascrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Lukas
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Enclosure Disassembly 5 |
|---|---|
| [* black] Disconnect the ribbon cable from the interface PC board located in the middle of the front enclosure. | |
| [* black] Disconnect the green ground wire and receptacle from the pneumatic unit (just above the outlet port). | |
| [* black] Disconnect the inverter cable from the top of the electronic module. | |
| [* black] With the LCD cable still tethered, lay the front enclosure, face down, on the protective surface. | |
| [* black] ''It is best to orient the front enclosure so that it is facing you, upside down with the tethered LCD cable towards the right'' | |
| [* black] Detach the green LCD cable ground wire from the LCD shield by removing the (1) 3mm x 14mm Phillips head screw and lock washer located in the corner near the LCD connector. | |
| [* black] Use the nutdriver to remove the (2) 4mm lock nuts from the LCD connector location on the front enclosure. Remove the aluminum U-shaped bracket from the LCD connector site and pull out the LCD connector and cable. | |
| [* black] Remove the aluminum U-shaped bracket from the LCD connector site and pull out the LCD connector and cable. |