crwdns2933803:06crwdne2933803:0
crwdns2933797:0Austen Schramcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Austen Schram
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Use drill to make necessary holes for screws to sit and fasten the bracket. |
|---|---|
| + | [* black] Use drill with drill bit to make necessary holes for screws to sit and fasten the bracket. ***I used a 3/36 inch drill bit*** |
| + | [* black] The more screws used, the stronger the bracket is secured. My build required 12***#6x1/2inch screws***. This is 6 on each bracket, and three on end of the bracket. |
| + | [* black] If possible, use preexisting holes, and screws if possible. I would suggest three screws per end of the bracket. (Two on the bottom of the bracket, and one on the inside of the track.) |
| + | [* icon_note] Sometimes screws protrude too far, you may have to grind the head of the screw slightly so it protrudes less. |