crwdns2933803:04crwdne2933803:0
crwdns2933797:0Duncan Applegarthcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Duncan Applegarth
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* red] Remove each of the plastic clips holding the motor cables in by snapping them out. |
|---|---|
| + | [* orange] Remove the two 9mm screws using a hex 2 bit. Once you remove these screws, the motor will hang freely from the leg chassis. |
| + | [* yellow] Remove the LED assembly by snapping it off the clips that are attached to the drone leg. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0