crwdns2933803:02crwdne2933803:0
crwdns2933797:0Jason SooHoocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jason SooHoo
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Choose a point along the power line to cut using wire strippers or end cutters. | |
| [* icon_caution] Be sure to note any damage on the power-line and if needed move your cut point to remove that damage. | |
| - | [* black] Take a new XT60 |
| + | [* black] Take a new XT60 male connector with pre-attached wires (at least 14 AWG) |
| [* icon_note] You can purchase these through Amazon or most hobbyist drone shops. | |
| [* black] A splice can be achieved by soldering the wires or utilizing crimp able connectors. | |
| [* icon_caution] Make sure that once the wire has been reassembled to electrically isolate any exposed wire using electrical tape or heat shrink. |