crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Austin Blakelycrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Austin Blakely

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Use the screwdriver to remove the two screws holding the mother board in place.
-[* orange] Before attempting to remove the board, disconnect the camera by removing the ribbon cable (shown in orange) from its corresponding connection on the board.
-[* blue] To remove the ribbon cable, use a plastic spudger to gently apply pressure to the lever (shown in blue) that secures the cable in place. While doing this, delicately pull the ribbon cable until it is fully disconnected.
-[* yellow] Now, disconnect the speaker connections (red and black wires, show in yellow) from the motherboard by applying pressure to the clip on its corresponding socket.
+[* red] Use the screwdriver to remove the two screws holding the motherboard in place.
+[* orange] Before attempting to remove the board, disconnect the camera by removing the ribbon cable from its corresponding connection on the board.
+ [* blue] To remove the ribbon cable, use a plastic spudger to gently apply pressure to the lever that secures the cable in place while simultaneously applying a light pulling pressure on the ribbon cable.
+[* yellow] Disconnect the speaker connections (red and black wires) from the motherboard by applying pressure to the clip on its corresponding socket.
[* black] Once all connections have been severed, gently remove the motherboard from the device casing.
-[* green] The speaker unit and corresponding mounting hardware should now be visible. (shown in green)
+[* green] The speaker unit and corresponding mounting hardware should now be visible.