crwdns2936039:0Kenwood DRV-N520 Dashcam Speaker Replacementcrwdnd2936039:03crwdne2936039:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Alexander A Mejiacrwdnd2933797:0Kul 8, 2020crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Austin Blakely

	[* black] Use the screwdriver to remove the two screws holding the mother board in place.
-	[* ~~black~~] Before attempting to remove the board, disconnect the camera by removing the ribbon cable (shown in orange) from its corresponding connection on the board.
+	[* orange] Before attempting to remove the board, disconnect the camera by removing the ribbon cable (shown in orange) from its corresponding connection on the board.
	[* black] To remove the ribbon cable, use a plastic spudger to gently apply pressure to the lever that secures the cable in place. While doing this, delicately pull the ribbon cable until it is fully disconnected.
-	[* ~~black~~] Now, disconnect the speaker connections (red and black wires, show in yellow) from the motherboard by applying pressure to the clip on its corresponding socket.
+	[* yellow] Now, disconnect the speaker connections (red and black wires, show in yellow) from the motherboard by applying pressure to the clip on its corresponding socket.
	[* black] Once all connections have been severed, gently remove the motherboard from the device casing.
	[* black] The speaker unit and corresponding mounting hardware should now be visible. (shown in green)