crwdns2933803:03crwdne2933803:0
crwdns2933797:0NathanGoodwincrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 NathanGoodwin
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Use the Phillips head to remove the two screws holding the mother board in place |
|---|---|
| + | [* black] Before attempting to remove the board, disconnect the camera by removing the ribbon cable (wide and flat) from its corresponding connection on the board (right hand side in picture shown) |
| + | [* black] To remove the ribbon cable, use a plastic spudger to gently apply pressure to the lever that secures the cable in place. While doing this, delicately pull the ribbon cable until it is fully disconnected. |
| + | [* black] Now, disconnect the speaker connections (red and black wires) from the motherboard by applying pressure to the clip on its corresponding socket. |
| + | [* black] Once all connections have been severed, gently remove the motherboard from the device casing. |
| + | [* black] The speaker unit and corresponding mounting hardware should now be visible. (Circular object adjacent to the camera unit) |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0