crwdns2933805:0crwdne2933805:0
crwdns2933797:0Andrew Kennedycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Andrew Kennedy
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Finally, to remove the remote control board, simply disconnect it from the logic board underneath it by gently pulling it up, wiggling it if necessary. |
|---|---|
| - | [* yellow] Note the connector position highlighted here. |
| - | [* black] There is a plastic clip holding the remote board in place on the board below it, remove it by sliding it towards the front (lens side) of the projector once the remote board is disconnected from the board below it. |
| + | [* black] Finally, to remove the remote control board, simply disconnect it from the logic board underneath it by gently pulling it up from the connector side, wiggling it if necessary. |
| + | [* yellow] Note the connector position, directly under the area highlighted here. |