crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0drmdolfancrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 drmdolfan

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Assembling
[* black] Assemble power bank back in reverse order. Install controller plate and battery back in frame.
-[* icon_caution] On battery installing try to put it in position where terminal strips are not stressed. It may spare next device disassembly on accidental drop on the ground.
-[* black] Insert assembled internal frame in outer case. Screw it to with two #0 screws. Put back cover in place.
-[* icon_caution] Back cover have only one possible direction. It have two bumps at back side and outer case bottom have two holes for them. See the photo.
+[* icon_caution] For the battery installation, try to place it in a position where the terminal strips are not stressed. It may prevent damage requiring disassembly should an accidental drop occur.
+[* black] Insert the assembled internal frame into the outer case. Screw it back down with the two #0 screws. Set the cover back into place.
+[* icon_caution] The back cover has only one possible orientation. There are two protrusions at the back side while the outer case bottom has two holes to receive them. See the photo.