crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0drmdolfancrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 drmdolfan

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Disassembling
-[* black] Top and bottom covers are glued with double sided tape. Insert prying tool at middle of bottom cover with model name. Slide it around cover to loose glue.
-[* icon_caution] Bottom cover have two small fixing pins at back side near both ends. Carefully press one of them with prying tool in center direction to free this cover side. Repeat the same in other cover side and remove cover.
-[* black] Remove two screws at corners with Philips #0 screwdriver.
-[* black] Turn power bank with sockets to bottom direction. Shake and pull internal frame out. If frame stuck, press several times at middle of case in all case length. Jimmy knife or thin metal stripe can be used carefully to free front side plate from outer case.
-[* icon_note] My device had slightly bent corner at top side near button as result of falling damage. It blocked internal frame removal. It required glued front cover and button (have same fixing pins as bottom cover, be careful) removal too. Case shape was restored with nut driver. It finally freed internals and I managed to pull them out from case.
+[* black] The top and bottom covers are fastened with double sided tape. Insert prying tool near the middle of the bottom cover where the model name is shown. Slide it around cover to loosen the tape.
+[* icon_caution] The bottom cover has two small pins at the back side near each end. Carefully press one of them with the prying tool towards the center to free that side. Repeat the same action for the other side and then remove the cover.
+[* black] Remove the two screws at each corner with the Philips #0 screwdriver.
+[* black] Turn power bank with sockets to bottom direction. Slide and pull the internal frame out. If the internal frame is stuck, press several times in the middle of the case and along the case length. Jimmy knife or metal spudger can be used carefully to free the front side plate from outer case.
+[* icon_note] My device had a slightly bent corner at the top side near the button as result of dropping damage. The bent metal prevented the removal of the internal frame. In order to free it for removal, it was necessary to remove the taped cover and button (it has the same pins as the bottom cover, be careful) The bent metal was restored by pressing it down.