crwdns2933803:01crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] The CR-20 Pro has solid bed mounts. If any X axis gantry alignment is needed, you can use the "nozzle to bed" distance to check. |
|---|---|
| + | [* orange] With M2.5 hex, loosen the 2 button head screws on the back side/ right of the X/Z Bracket. |
| + | [* green] If the right side is too low and needs to go up, squeeze the bracket and rail together while tightening the button head screws. |
| + | [* icon_note] If the right side is high and needs to be lowered, you will squeeze the bottom wheel against the X rail while tightening. |
| + | [* blue] When properly adjusted, the nozzle will be the same distance from the bed from left to right. |
| + | [* icon_note] In some cases, it is necessary to do this process on the left side (near extruder motor) but requires partial disassembly of the machine. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0