crwdns2933803:02crwdne2933803:0
crwdns2933797:0Navy Vet 2015crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Navy Vet 2015
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Drive PCB | |
| [* red] Remove two PH1 screws | |
| [* green] Gently pull up on the ribbon retaining tab. Do NOT pull on ribbon. It will slide itself out in final step | |
| [* icon_note] Orange/Yellow steps only required if you need to remove the entire PCB | |
| [* orange] Gently pull up on the ribbon retaining tab. Ribbon is attached to underside of PCB via a sticky pad. Gently pull the ribbon away from pad | |
| [* yellow] Desolder both points. Red (Left) Black (Right) | |
| [* black] Gently press up on the PCB where you removed the two PH1 screws and rotate the board upside down | |
| - | [* icon_note] If your drive is "dead" this is where I would suggest replacing your electrolytic capacitors. There are 12 on the |
| + | [* icon_note] If your drive is "dead" this is where I would suggest replacing your electrolytic capacitors. There are 12 on the Thomson drive |