crwdns2933803:09crwdne2933803:0
crwdns2933797:0Amanda Smithcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Justin Ogihara
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Re assemble | |
| - | [* black] Push the board back into the case. Make sure the back USB and micro SD card |
| + | [* black] Push the board back into the case. Make sure the back USB and micro SD card flaps are attached. Check you can open the flaps when the board is pushed in. |
| [* black] The smallest single black screw goes in the back | |
| [* black] The two smallest black screws hold the battery in. I used a bit of bluetack to hold onto the screw driver. | |
| [* black] One screw is tight to get in. I used a small flat bladed screwdriver held at an angle |