crwdns2933803:09crwdne2933803:0
crwdns2933797:0Martin Hamptoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Martin Hampton
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Re assemble |
|---|---|
| + | [* black] Push the board back into the case. Make sure the back USB and micro SD card flap are attached. Check you can open the flaps when the board is pushed right in |
| + | [* black] The smallest single black screw goes in the back |
| + | [* black] The two smallest black screws hold the battery in. I used a bit of bluetack to hold onto the screw driver. |
| + | [* black] One screw is tight to get in. I used a small flat bladed screwdriver held at an angle |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0