crwdns2933803:01crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Y End Stop Adaptor |
|---|---|
| + | [* icon_reminder] Retain all fasteners until after assembly. |
| + | [* black] Find the file for printing at http://bit.ly/2RFHGyT |
| + | [* black] To start this process, you will need to remove all 4 corner leveling knobs. There may also be a star washer between the knob and Y carriage plate on each corner. |
| + | [* yellow] The screw that is not allowing the new chain to sit flat, needs to be removed. Use an M2.5 hex for this. |
| + | [* green] The screw is no longer needed. |
| + | [* orange] The raised part sits closer to one side. It should face the end stop. |
| + | [* orange] Test fit the printed part first to make sure it sits all the way flush. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0