crwdns2933423:0crwdne2933423:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Phrynecrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Phryne

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

+[title] Troubleshoot
+[* black] Now, let’s tear off the High Temperature Protective Tape. Turn the flex cable upside-down and secure it again. Remove the Flood illuminator module with Hot Air Gun at 240℃.
+[* black] Prepare a new flex cable. Apply some Paste Flux to the bonding pad and get the detached Flood illuminator module in position. Be careful with the direction.
+[* black] Solder with Hot Air Gun at 240℃. Once done, remove residual glue on the module. Secure the flex cable with double-sided tape.
+[* black] Apply some Paste Flux to bonding pad of the ambient light sensor module. Then apply solder paste to the bonding pad with Soldering Iron.

crwdns2933777:01crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0