crwdns2933803:04crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Teardown |
|---|---|
| + | [* yellow] Loosen the 4 socket head cap screws with M2.5 hex until the horseshoe is loose. |
| + | [* orange] Remove the horsehoe. |
| + | [* green] The hot end can now be removed by pulling it down and out of the printed body. |
| + | [* red] If it is stubborn, you can gently pry between the top fin and printed mount with a flat screwdriver. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0