crwdns2933803:03crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Teardown |
|---|---|
| [* yellow] Unplug the part cooler fan. | |
| [* orange] Unplug the hot end fan. | |
| [* blue] Remove the hot end fan and holder. Grab the fan with your thumb and index finger and pull it 180 degrees from the opening. | |
| [* green] Using a small flat tip screw driver, loosen the phoenix connector to release the heater wires. | |
| [* violet] Unplug the thermistor connection. | |
| [* yellow] Remove the bottom 2 motor screws. | |
| [* orange] Remove the 2 upper motor screws. They also hold the lever in place, which is under spring tension. | |
| [* red] Squeeze the lever down while removing or installing the upper 2 to help align the holes. |