crwdns2933803:03crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Teardown |
|---|---|
| + | [* yellow] Unplug the part cooler fan. |
| + | [* orange] Unplug the hot end fan. |
| + | [* blue] Remove the hot end fan and holder. Grab the fan with your thumb and index finger and pull it 180 degrees from the opening. |
| + | [* green] Using a small flat tip screw driver, loosen the phoenix connector to release the heater wires. |
| + | [* violet] Unplug the thermistor connection. |
| + | [* yellow] Remove the bottom 2 motor screws. |
| + | [* orange] Remove the 2 upper motor screws. They also hold the lever in place, which is under spring tension. |
| + | [* red] Squeeze the lever down while removing or installing the upper 2 to help align the holes. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0