crwdns2933803:03crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* yellow] After feeding the short harness into the control box, note where everything is connected in case you have remove things like the LCD connections to access the new connection points. |
|---|---|
| + | [* green] Plug in the 3 pin connector to D11 row with the red wire on the V pin. For CR-10S machines, it is the pin closest to the LCD connections. |
| + | [* icon_note] Unplug the Z end stop wires from the motherboard (not shown) |
| + | [* orange] Plug in the 2 pin connector where the original Z end stop was plugged in. This is Z- for CR-10S machines. |
| + | [* icon_note] Hot glue is optional. |
| + | [* light_blue] Zip tie the newly added harness to the original harness group for strain relief. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0