crwdns2933803:02crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* orange] With the grommet loose, you can feed the 2 and 3 pin connector through the grommet and feed it through the hole in the rear of the control box. |
|---|---|
| + | [* orange] With the grommet loose, you can feed harness A through the grommet with the 2 and 3 pin connector going first. |
| + | [* icon_note] Feed it through the hole in the rear of the control box. |
| [* light_blue] Leave 4-5 inches of the loose pins and reinstall the grommet. | |
| - | [* |
| + | [* icon_note] Make sure the grommet is fully seated into the hold. |