crwdns2933803:01crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* icon_caution] Before you begin... |
|---|---|
| + | [* red] Turn the power switch to OFF |
| + | [* orange] Unplug the power cable |
| + | [* yellow] Using an M2 hex, remove the 5 button head screws holding the control box bottom cover on. |
| + | [* yellow] using an M2.5 hex, remove the 4 button head screws holding the power supply to the control box. |
| + | [* green] Lay the power supply to the side as shown. |
| + | [* violet] Remove the grommet from the rear of the control box and pull back a few inches as shown. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0