crwdns2933803:07crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Bottom Section 1a. | |
| [* yellow] Using a #1 Phillips screwdriver, remove the 11 screws on the bottom and 2 screws on each side for a total of 15. Next, remove the bottom cover. | |
| [* black] Unplug the original ribbon cable (not shown) | |
| [* black] Plug in new connections. | |
| [* violet] Ribbon Cable (keyed) | |
| - | [* yellow] 3 pin black plug into D11 ( |
| - | [* orange] 2 pin white plug into Z+ (connection closest to the ribbon cable, right 2 pins |
| + | [* yellow] 3 pin black plug into D11 (end row towards SD card slot) Orange wire will face the ribbon cable like in the picture. |
| + | [* orange] 2 pin white plug into Z+ (connection closest to the ribbon cable) From the same view as the picture, use the right 2 pins. |
| [* icon_note] Hot glue is optional. |