crwdns2933803:05crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Top Section 2b. | |
| [* yellow] Tighten button head screws with M2 hex. Start with the top 2 then position the bottom tab, aligning the holes to install the 3rd screw. | |
| [* light_blue] Add new zip ties to hold the cable loom in place. | |
| [* orange] On the hot end/probe side, route the wires behind the hot end and plug into the probe. | |
| + | [* icon_caution] Be sure that the probe wires are not pinched between the X carriage and probe mounting bracket. |
| [* red] Install and tighten the button head screws. |