crwdns2933803:03crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Top Section 1c. | |
| [* light_blue] Cut 2 zip ties. | |
| [* yellow] Remove 3 button head screws using M2 hex to remove the daughterboard cover. | |
| [* orange] Unplug the original probe connector. It may have glue on it so pull on the connector, not the wires. | |
| [* icon_note] Daughterboard is marked with pink arrows. | |
| + | [* icon_caution] No jumper needed for this install. We will not be using Z- port so these instructions are specific to using our firmware! |