crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Ella Leiningercrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Taylor Dixon

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Attach Wires
-[* black] A wire is necessary on the ground, SDA, SDO, SCK, CS, Vd and VdIO pins. These can be identified from the top of the board and with the sensor's datasheet. Take a wire and strip 1/4 of an inch of insulation off one end, insert it into the through hole, and solder it into place. Repeat for all seven wires.
+[* black] A wire is necessary on the ground, SDA, SDO, SCK, CS, Vd and VdIO pins. These can be identified from the top of the board. Take a wire and strip 1/4 of an inch of insulation off one end, insert it into the through hole, and solder it into place. (Tip: consider which way you want your wires to run). Repeat for all seven wires.