crwdns2933803:02crwdne2933803:0
crwdns2933797:0Anne Georgecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Anne George
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Cut Pins | |
| [* black] The factory pins must be removed and replaced with wire. | |
| - | [* red] To do so, first cut along the red line in the photo to separate the pin from the board. |
| + | [* red] To do so, first cut along the red line in the photo using wire clipper to separate the pin from the board. |
| [* blue] Next, clip vertically along the blue line to disconnect the pin from the one next to it. | |
| [* icon_caution] Be very careful while cutting to not damage the board! Rough handling can rip out the copper pad of the through hole, ruining the board. | |
| + | [* icon_note] Can use pliers to remove pieces after being cut |