crwdns2933803:01crwdne2933803:0
crwdns2933797:0Michael Stembercrwdnd2933797:0crwdne2933797:0
crwdns2936045:0crwdne2936045:0 crwdns2933505:0crwdne2933505:0 Kyle Smith
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Heat the edge of the back panel | |
| [* black] [guide|25705|Heat an iOpener|new_window=true] and apply it to the right edge of the back panel for a minute. | |
| [* icon_note] A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the display and internal battery are both susceptible to heat damage. | |
| [* black] While you wait, note the following areas on the back panel: | |
| - | [* red] Strong adhesive—there are large patches of adhesive near the bottom of the phone. |
| + | [* red] Strong adhesive—there are very large patches of adhesive near the bottom of the phone that go up nearly an inch. The blue picks in the kit will almost disappear into the phone. |
| [* orange] Fingerprint sensor cable—be careful not to slice through the cable as you pry |