crwdns2933423:0crwdne2933423:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Austin Blakelycrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Austin Blakely

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Remove the two 5/8 rear main cap bolts. Gently tap the side of cap with a rubber mallet if needed to break free.
+[* red] Remove the two 5/8 rear main cap bolts. Gently tap the side of cap with a rubber mallet if needed to break free.
[* black] Remove the rear main seal. The upper half of the seal can easily be removed by hand.
[* black] Loop the new bottom half of the seal through the slot indicated in picture.
-[* black] ***NOTE*** Needle nose pliers may make this easier but be cautious not to handle the new seal too aggressively so you do not damage it .
+ [* icon_note] Needle nose pliers may make this easier but be cautious not to handle the new seal too aggressively so you do not damage it .
[* black] Put the rear main cap back and torque to specs (65 ft.-lbs.) followed by the oil pump and torque to specs (60-70 ft.-lbs.)