crwdns2933803:013crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] |
|---|---|
| + | [title] Cable Chain Installed |
| [* icon_note] Reference steps 1 and 2 to reassemble the bed heater power plug. | |
| [* icon_caution] Leave the power cable unplugged to test the thermistor. | |
| [* black] With everything hooked back up, you should be satisfied with your work! | |
| [* black] After double checking that all wire connections are tight, it is a good time to test that both the thermistor work (in that order). You can plug in just the control box, display to test the thermistor. | |
| [* black] If the thermistor is not plugged in (or broken), bed temperature will read -14. | |
| [* black] If you have a normal ambient temperature reading on the display, you can test that the bed heats by going to manually setting the bed temperature to a low value of 50. |