crwdns2933803:011crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [title] Reassembly |
|---|---|
| + | [title] Reassembly 1c. |
| [* green] Resecure cables to the machine | |
| - | [* green] Make sure you secure the cable bundle on each end of the cable chain. |
| + | [* green] Make sure you secure the cable bundle on each end of the cable chain with a cable tie. |
| [* green] Be sure to trim cable tie ends off flush so they are not sharp. | |
| - | [* yellow] Tighten up the frame side chain hold down with a M2.5 hex wrench. |
| + | [* yellow] Tighten up the frame side chain hold down with a M2.5 hex wrench. This side uses a T Nut and you need to make sure the chain is tight to the frame before proceeding. |
| [* violet] This screw triggers the end stop. Make sure you position the chain so that it is clear of this screw. | |
| - | [* green] Reinstall bed heater connections to the relay |
| - | [* yellow] |
| + | [* green] Reinstall bed heater connections to the relay. They are not polarity specific (side does not matter). |
| + | [* yellow] Using a #1 phillips screwdriver, tighten the screw terminals. |