crwdns2933803:08crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Removing the old cable chain | |
| [* violet] Tape the end of the thermistor wires to the orange sleeve. This will make install easier later | |
| - | [* black] |
| + | [* black] Pull the old chain off the machine. |
| [* yellow] Hold the wires on the bed side. | |
| [* green] Start pulling the cable chain away from the bed. | |
| [* light_blue] With the old chain fully removed, notice the taped end. This will make install into the new chain much easier. | |
| [* icon_caution] Be gentle! If the cables get stuck, pull the wire back through and inspect your taped areas. They must be smooth and small to fit through the old chain then retry |