crwdns2933803:08crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Disassembly 1g. |
|---|---|
| + | [* violet] Tape the end of the thermistor wires to the orange sleeve. This will make install easier later |
| + | [* black] Pull the old chain off the machine. |
| + | [* yellow] Hold the wires on the bed side. |
| + | [* green] Start pulling the cable chain away from the bed. |
| + | [* light_blue] With the old chain fully removed, notice the taped end. This will make installing into the new chain much easier. |
| + | [* icon_caution] Be gentle! If the cables get stuck, pull the wire back through and inspect your taped areas. They must be smooth and small to fit through the old chain then retry |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0