crwdns2933803:01crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Disassembly 1a. | |
| - | [* icon_caution] Make sure all power cables to your 3D Printer are unplugged including wall plugs ( |
| + | [* icon_caution] Make sure all power cables to your 3D Printer are unplugged including wall plugs (A/C) and/or USB cables. |
| [* icon_note] All screws and fasteners are right-hand thread. That means righty tighty, lefty loosey. During this procedure, ++keep all screws and hardware for reassembly.++ | |
| - | [* black] All work |
| + | [* black] All work will be on the lower frame assembly so start by disassembling your Raptor 2 / T REX 3 machine and getting to the point in the picture. |
| [* red] Remove any filament that is installed. | |
| - | [* orange] Unplug all connections between upper and lower frame, including the LED, DB15 cables to each print head |
| + | [* orange] Unplug all connections between upper and lower frame, including the LED, DB15 cables to each print head and X and Z axis connections. Unplug and remove the display. |
| [* yellow] Remove the chassis ground (if installed) then remove the control box. | |
| - | [* green] Remove the 8mm socket head screws that hold the upper frame to the lower frame and push the bed all the way forward. |
| + | [* green] Remove the 8mm socket head screws (2) that hold the upper frame to the lower frame and push the bed all the way forward. |
| [* light_blue] Double check that no wires are attached and lift off the upper frame. |