crwdns2933803:01crwdne2933803:0
crwdns2933797:0Tiny Machines 3Dcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tiny Machines 3D
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Disassemble 1a. | |
| [* icon_caution] Make sure all power cables to your 3D Printer are unplugged including wall plugs (AC) and/or USB cables. | |
| - | [* icon_note] All screws and fasteners are right-hand thread. That means righty tighty, lefty loosey. Keep all screws and hardware for reassembly. |
| + | [* icon_note] All screws and fasteners are right-hand thread. That means righty tighty, lefty loosey. ++Keep all screws and hardware for reassembly.++ |
| [* black] All work to be done is on the lower frame assembly so start by disassembling your Raptor 2 / T REX 3 machine and getting to the point in the picture. | |
| - | [* red] Remove any filament that is installed |
| + | [* red] Remove any filament that is installed. |
| [* orange] Unplug all connections between upper and lower frame, including DB15 cables to each print head, X axis connections and Z motor connections. Unplug and remove the display. | |
| - | [* yellow] Remove the chassis ground (if installed) then remove the control box |
| + | [* yellow] Remove the chassis ground (if installed) then remove the control box. |
| [* green] Remove the 8mm socket head screws that hold the upper frame to the lower frame and push the bed all the way forward. | |
| + | [* light_blue] Double check that no wires are attached and lift off the upper frame. |