crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0John Burkeecrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 John Burkee

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Use your soldering iron and heat up the solder that holds the two wires from the motor to the main computer. Once the solder melts use your desoldering pump to desolder the wires to the main computer.
-[* black] ***Note: At this point the motor can be completely removed. You will need to solder the new motor wires in the same spot as the old motor wires, so pay attention to where the different color wires attach to the main computer.***
+[* black] At this point, pay attention to where each color wire attaches to the computer. Write down which color wire goes where.
+ [* black] ***It is very important that you connect the new motor wires in the same location as the old wires and pay attention to which color wire attaches to each location. ***