crwdns2933803:01crwdne2933803:0
crwdns2933797:0a1235crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 a1235
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Locate the terminals that need to be removed. | |
| [* black] Clean the terminals with isopropyl alcohol and an old tooth brush. | |
| [* icon_note] Attach a heat sink to the soldering iron to dissipate the heat. | |
| [* icon_note] Make sure to clean the soldering iron while in use. | |
| - | [* |
| + | [* red] Press the end of the pump until it clicks in place, then, using the tip of your soldering iron, heat the solder until it melts. |
| [* black] Touch the tip of the de-soldering pump to the solder pad ++without++ applying pressure. | |
| [* black] Empty the de-soldering pump into the trash then clean the board with isopropyl alcohol and the toothbrush again. | |
| [* icon_caution] Be careful when using a soldering and de-soldering device as it is ++very hot++. |