crwdns2933803:02crwdne2933803:0
crwdns2933797:0Michael Papadopolouscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Michael Papadopolous
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* icon_note] Locate the 5 black screws securing the heat sink to the backboard. |
|---|---|
| + | [* black] Use the #0 phillips screwdriver to remove all 5 black 1/8 inch screws. |
| + | [* black] Then wedge the plastic tool in between the edge of the heat sink and the aluminium perimeter. |
| + | [* black] Gently pry up on the heat sink until it is lose enough for you to remove. Then grab and remove the heat sink. |
| + | [* icon_caution] If it does not work in the first position that you tried, try another. Do not pry too much in one position because it could damage the components of the heat sink. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0