crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Chad Petersoncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Chad Peterson

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Slowly loosen the T20 7mm torx screw holding the lever in place. There is a compression spring behind this screw.
-[* yellow] As soon as the screw is free from the last thread, slowly back the screw away allowing the compression spring to release pressure.
+[* red] Slowly loosen the 7mm T20 screw holding the blade angle guide lever in place. There is a compression spring between this screw and the lever.
+[* yellow] After the screw is loose from the last thread, slowly back the crew away from the lever gradually releasing pressure in the spring.