crwdns2933803:08crwdne2933803:0
crwdns2933797:0Clay Eickemeyercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Clay Eickemeyer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Further strengthen the adhesive bond |
|---|---|
| + | [* icon_note] Once you've installed your part or sealed up your device, you can strengthen the bond by heating up the adhesive. |
| + | [* icon_note] Soft adhesives, which are usually messy and hard to clean, benefit from a reheat. |
| + | [* icon_note] Harder adhesives that resemble tape may not benefit as much, but the heat can help the adhesive fill in gaps. |
| + | [* black] Use a [guide|157348|hair dryer|new_window=true], [guide|25705|iOpener|new_window=true], or [guide|151116|heat gun|new_window=true] to lightly heat the part or closed device in the areas where the new adhesive was applied. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0