crwdns2933803:016crwdne2933803:0
crwdns2933797:0Justin Krupinskicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Justin Krupinski
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Use the 10mm and 12mm wrench to adjust and tighten the axle blocks. |
|---|---|
| + | [* black] Once axle blocks are in the correct position, tighten the rear axle using the 30mm socket and breaker bar. |
| + | [* black] Use the 10mm and 12mm wrench to tighten the axle blocks. |
| [* icon_note] Ensure there is a small amount of slack in the chain. The 3 finger method displayed is a good rule of thumb when determining chain slack. | |
| - | [* |
| + | [* icon_note] Check to make sure wheel spins freely with new chain installed. |