crwdns2933803:02crwdne2933803:0
crwdns2933797:0Wayne Seltzercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Wayne Seltzer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Check the safety switch wiring and connector |
|---|---|
| + | [* black] Use a small clamp to push down the safety switch that detects that the top cover has been removed. The mower will not run if this switch isn't pushed. |
| + | [* black] Extend the mower handle to the operating position. The mower will not run if handle isn't extended. There's a micro switch in the handle latch assembly, on the side with the cable. |
| + | [* black] Connect the battery box. Be sure to put the correct wires on each of the 3 terminals. |
| + | [* black] Insert the battery. Push down hard until it clicks. |
| + | [* black] Start the mower with the handle switch. |
| + | [* black] Locate the 3-wire cable and connector on the logic board that connects to the safety switch in the handle. ([guide|125314|See the video]) Wiggle this cable to see if the motor starts or stops. |