crwdns2933805:0crwdne2933805:0
crwdns2933797:0Charlotte Prattcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Charlotte Pratt
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Preparing the 2-inch Pipe for Connection | |
| [* red] Ask the workshop to make a lengthwise slit on either side of the 2-inch pipe from the end without the pipe bushing to about 1 inch above the 2.5 foot mark(this 1 inch gap is shown in the 2nd image). These slits will make it easier to slide the 1.5 in pipe in and out | |
| [* orange] Coat the inside of this section with the lubricant | |
| - | [* yellow] Insert the 1.5-in pipe into the 2-in pipe |
| - | [* green] Slide the 1.5-in pipe as far in as needed, and use a hose clamp to secure the two pipes together at this desired height |