crwdns2933805:0crwdne2933805:0
crwdns2933797:0Charlotte Prattcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Charlotte Pratt
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Preparing the 2-inch Pipe for Connection |
|---|---|
| + | [* red] Ask the workshop to make a lengthwise slit on either side of the 2-inch pipe from the end without the pipe bushing to about 1 inch above the 2.5 foot mark(this 1 inch gap is shown in the 2nd image). These slits will make it easier to slide the 1.5 in pipe in and out |
| + | [* orange] Coat the inside of this section with the lubricant |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0