crwdns2933803:021crwdne2933803:0
crwdns2933797:0Brooke Masoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Brooke Mason
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Terminal Block #1 | |
| - | [* black] Obtain |
| + | [* black] Obtain four 5-position pluggable header blocks for connecting the sensors to the Open-Storm board. |
| [* icon_note] Terminal block #1 is for the pressure transducer. | |
| - | [* red] Insert a 150 Ohm resistor into terminal block #1 as shown. |
| + | [* icon_note] Images are shown connecting the terminal blocks outside of the node to make it easier to follow. But these steps should be completed inside the node. |
| + | [* red] Insert a 150-Ohm resistor into terminal block #1 as shown. |
| [* orange] Insert the white data wire from the pressure transducer into the second slot (with one of the resistor prongs). | |
| [* yellow] Insert the black ground wire from teh pressure transducer into the third slot (with the other resistor prong). | |
| [* green] Use a screwdriver to screw the wires and resistor into place. | |
| [* icon_note] Note: Hand tight is just right. |