crwdns2933803:021crwdne2933803:0
crwdns2933797:0Brooke Masoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Brooke Mason
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Terminal Block #1 | |
| [* black] Obtain 4 5-position plugable header blocks | |
| - | [* icon_note] This block is connected to the pressure transducer |
| - | [* icon_reminder] Remember to thread the pressure transducer through the smaller of the two holes in the node enclosure before connecting the wires to terminal blocks. Otherwise, the wires will prevent the box from closing. However, images in the following steps are shown without threading the sensors through for easier visualization. |
| - | [* red] Put a 150 Ohm resistor into the terminal block as shown |
| - | [* orange] Insert the white data wire into the second slot (with one of the resistor prongs) |
| - | [* yellow] Insert the black ground wire into the third slot (with the other resistor prong) |
| - | [* green] Use a screwdriver to screw the wires and resistor in |
| - | [* icon_note] Note: Hand tight is just right |
| + | [* icon_note] Terminal block #1 is for the pressure transducer. |
| + | [* red] Insert a 150 Ohm resistor into terminal block #1 as shown. |
| + | [* orange] Insert the white data wire from the pressure transducer into the second slot (with one of the resistor prongs). |
| + | [* yellow] Insert the black ground wire from teh pressure transducer into the third slot (with the other resistor prong). |
| + | [* green] Use a screwdriver to screw the wires and resistor into place. |
| + | [* icon_note] Note: Hand tight is just right. |